Monday, October 15, 2018

Dryer Vent Cleaning

Dear Residents:

Your dryer vents will be cleaned on:
Tuesday, October 23, 2018
Dryer Vent Solutions will be cleaning every unit from the outside. Their cleaning tools will clean to the flexible hose behind the dryer. No lint will blow into the apartment. Access inside your unit will not be necessary unless we have been informed that a definite drying problem exists with your dryer. If so, we may arrange to enter your residence and clean from behind your dryer.

Extra Inspection/Cleaning:

For a nominal charge, a dryer vent cleaning technician will enter your unit and perform the following:
  1. Replace, repair or clean the hose behind your dryer as needed.
  2. Clean the lint build-up in the compartment behind the lint screen.
  3. Test dryer airflow to insure it is blowing at maximum performance.
$22.95 plus sales tax = $25.00 We accept cash, checks and credit cards.
Service must be performed during the scheduled time we are on-site.
Call 425-398-5001 to schedule an appointment.

Annual Fire Alarm Inspection

On Tuesday, October 23rd, 2018 beginning at 8:30 am, Custom Security Systems will be conducting our annual fire alarm test mandated by the Everett Fire Department.

Everyone (including renters) will need to participate. This bulletin is to serve as notice that you are required per the Association’s by-laws to allow them access to your unit and garage. Every unit will be inspected, no exceptions. A Board Member (or Board representative) will be present to oversee your unit’s inspection.

They will also inspect the central alarm and fire extinguishers. The main alarm is very loud and will be tested several times in each building that day. Please refrain from disconnecting your smoke detector in a futile attempt to kill the noise in your unit. It is not your smoke detector that is making the noise, although it would be a good time to make sure that your smoke detector is working properly:

  • First locate your smoke detector, attached to the ceiling, in your hallway.
  • Examine the smoke detector for a little round “test” button. All detectors have one. Press and hold the test button for a few seconds to see if it beeps. If it does, your detector is working properly. If not, remove the smoke detector and check your batteries. Batteries should be replaced twice a year. 
  • According to the manufacturer’s instructions, all smoke detectors should be replaced after 10 years of use. The date will be listed on the back of the detector. If there is no date on the smoke detector, it is over 10 years old and needs to be replaced.
  • If you hear your smoke detector “chirping” (it continuously beeps every few seconds up to a minute). This is an indication that the battery needs to be replaced.

Washington State law (RCW 19.27.530) requires carbon monoxide alarms to be installed in new residences. As of January 1, 2013, carbon monoxide alarms are required in existing apartments, condominiums, hotels, motels, and single-family residences, with some exceptions. Owner-occupied single-family residences, legally occupied before July 26, 2009, are not required to have carbon monoxide alarms until they are sold. To comply, simply install the CO alarms in the area right outside of each bedroom. They can be found in most hardware stores, etc.

Please provide us with a key to your unit or be home on that day so that your unit can be inspected. Keys should be marked with your unit number and dropped in the HOA black drop-box. We will leave your keys on the counter and lock the door behind them. Please use the enclosed form to indicate whether you will be home, or leave keys, etc.

A locksmith will be on-hand to provide emergency access to units which are not accessible at the time of inspection. All locksmith costs will be charged back to the units which incurred them.

Thank you,

The Board of Directors


Board Meeting Minutes: September 20, 2018

The Board Meeting Minutes for September 20, 2018 have been published in the Minutes section of the website.

Wednesday, October 10, 2018

Siding Painting

Finally getting around to paint the new HardiPlank siding on building 2.